KT92 - 150, 200 and 400 kg/h
DEMKO, PED approvals and CE marked (Zone 1)

  • Gas inlet connection
  • Gas outlet connection
  • Gas probe
  • Safety relief valve
  • Water drain plug
Product Description :
Model KT 92

Indirect electrically heated water bath vaporizer

Classification : Zone 1

Model range : 150 200 400 kg/h

Operating temperature range : 40°C - 70°C

This range of safe and reliable LPG vaporizers makes it possible to cover any requirements in restaurants, small industrial enterprises and greenhouses where natural vaporization of LPG is not sufficient to cover the demand.

KT 92 has been approved according to the highest safety standards allowing it to be placed in Zone 1 (Hazardous Area). Safety distance is not required.

Kosangas LPG recommends that all installations be carried out according to local rules and regulations.

Easy to install and maintain :

KT 92 enables quick installation at low cost. No external control box is needed. Maintenance is minimal and all parts including heating elements are easy to replace. Kosangas LPG recommends the use of anticorrosion/antifreeze (glycol) solution to provide the necessary protection of the water chamber against corrosion and frost.

Technical Description :

KT 92 is equipped with the following technical features:

  • Solenoid valve (On/Off) controlled by a thermostat.
  • Temperature sensor protects against liquid penetration and overloading.
  • Two (2) level switches disconnect power supply if the water level in the water chamber drops below a pre-specified minimum. Automatic start-up upon refill of water/glycol solution.
  • Safety relief valve protects the pressure vessel against unacceptable pressure increases.
  • Explosion-proof (Zone 1) execution.
  • Flameproof top compartment.
  • Mechanical thermostats.
  • Colour : Green RAL 60-24
  • If two or more units of KT 92 400 kg/h are required for an installation to achieve a capacity higher than 400 kg/h, each vaporizer should be equipped with a thermovalve KTV 500 (see separate data sheet).
Test pressure : 32.5 bar (470 psi).
Relief valve :
Normal set point 25 bar (360 psi) or 17 bar (250 psi).
Classification Zone 1 :

EEx d m II A T3,
EN 50014, EN 50018, EN 50020, EN 50028


Approvals :
DEMKO (UL subsidiary) and PED (Pressure Equipment Directive) with CE marking.
Scope of supply :
  • Installation and maintenance manuals
  • Pressure and electrical test certificates
  • Transport pallet
Optional Features :
  • Oil separator for drainage of residues
  • Regulators
  • Crating of vaporizer
  • Power supply cable
  • Flanges for gas connection
  • Thermovalve KTV 500 for parallel connection
Capacity kg/h
Gas Inlet /
Outlet
Norm
Connected
Load
KW
Water
Volume
Litre
Voltage
V
50/60 Hz
Weight
Net
kg
Height
A
mm
Width B
mm

Dimension C
mm

Dimension
D
mm
150
DN 25 DN 25
24.0
210
220 - 500
235
1,440
650
570
295
200
DN 25 DN 25
30.0
210
380 - 500
235
1,440
650
570
295
400
DN 25 DN 25
54.0
285
380 - 500
310
1,880
650
1,070
295
 

Contact Us